Paver sealing for Cedar Hills homes
Paver Sealing in Cedar Hills, FL
Cedar Hills Estates homes date from 1955 to 1971, so call (904) 849-6734 to ask what coat your pavers carry.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Fast, careful paver sealing in Cedar Hills
Paver sealing in Cedar Hills starts with a free estimate for the drive, the patio by the sliding door or the walk. A local contractor serves the Estates, Sweetwater and the river lots. Ask through book your free estimate and expect to hear back in 1 business day or less, usually much sooner.
Maybe the patio outside your sliding door has gone gray and the drive's joints hold more weeds than sand. After a wash, new sand and a coat, the patio matches the drive again. To talk first, call (904) 849-6734 and tell the contractor what you see.
Why hire a local paver sealing contractor in Cedar Hills?
Cedar Hills homes were built mostly in the 1950s, and the pavers around them were added later by owner after owner. A local contractor sorts out which coat sits where, so begin with book your free estimate.
From Blanding to the river
Quotes are open across Cedar Hills, from the Estates streets to Sweetwater and the lots along the Cedar River.
Prices you can compare
The published Northeast Florida figure is $1.75 to $3.25 per square foot, and a long Cedar Hills drive tends to cost less per foot than a small patio.
Honest about old coats
If an oil-based coat is down, the quote should say whether it must come off before anything new goes on.
Your property, your call
Many Estates listings report no HOA, so the date and finish are yours to pick. A quote leaves you free to walk away.
Get Your Free Estimate in Cedar Hills
Tell us about your pavers in Cedar Hills.
Free, no obligation
What paver problems show up most in Cedar Hills?
Pavers added by several owners
Cedar Hills Estates homes were built from 1955 to 1971, with a median year of 1960, so most lots have changed hands many times. Each owner may have added or redone pavers with a different product. A water-based coat cannot go over a solvent-based one, and one Jacksonville company strips old oil-based coats on about 10 to 20 percent of its projects. The old coat has to be identified before anything new goes on. Sealer from an unknown product can leave a patchy look where one owner coated and the next did not, so a sample patch on a hidden corner is worth doing. Cedar Hills has about 3,000 single-family homes, and that many lots means a lot of pavers with a lot of different histories. If a coat is peeling in patches, that is a clue worth mentioning at the first visit, and so is any receipt from a past job.
Joint sand lost to summer rain
Duval County sits on sand. The USDA describes the Ortega soil series, first described in this county, as fine sand more than 80 inches deep with rapid permeability. Add roughly 52 inches of annual rainfall, most of it between May and September, and joint sand leaves quickly. One Jacksonville company names sinking and washouts as the top failure for pavers. Along the drive, sand often thins first near the garage, where tires and runoff meet. With lot frontages as wide as these, a drive can carry a long run of exposed joints from the garage to the street. Fine sand drains fast, which is good for a yard but hard on paver joints, so joints here are worth topping up on a schedule.
Water from a clogged ditch
Cedar Hills has a large network of drainage ditches and canals, and a 1959 aerial of the Estates shows a street grid built around them. In 2017 News4JAX reported a blocked storm drain and ditch that sent water onto neighboring properties and caused the ground to cave in. Pavers near a ditch can take extra water and silt. Wash them well before sealing, since a coat would trap the film, and point out any ditch bank beside your drive at the first visit. A neighbor's ditch matters as much as your own, so mention any shared drainage you know of. A contractor who sees silt lines on the pavers can tell how high the water has come, which guides how much rinsing to plan.
Fade on sunny drives
Cedar Hills lots have wide frontages, so driveways run long. One Jacksonville company puts full-sun driveways at about 18 to 24 months between reseals, while shaded walkways with light traffic run about 24 to 36 months. Check a long, sunny run of pavers sooner than a shady side walk. Long drives also hold afternoon sun for hours, which is why a morning start makes sense. On a corner lot along Harlow Boulevard or Jammes Road, a second drive or a side walk may need the same check. Ask the contractor which parts of the drive show the most fade, since a sample patch can show how the finish will look. A long drive may also be worth sealing in two sections on separate days so the whole length stays dry.
Slick spots on pool decks
Cedar Hills Park has a public pool, and a pool deck of your own raises the same question. Smooth glossy sealer can feel slippery when wet. Matte is the usual pick near a pool, and an anti-slip additive is worth asking about before the sealer goes on. Test a small corner first, and give the deck its full stay-off time. A deck on the river side of the neighborhood may stay damp longer under tall trees, so ask about drying time. A smooth deck can look fine dry and still be risky wet, so test the finish with water.
Is a Cedar Hills ranch handled differently from a rebuilt river house?
Yes, because the housing mix looks different on either side of the neighborhood. American Ranch homes dominate, with sliding glass doors that open to patios, but many along the Cedar River have been expanded or replaced with much larger homes. Older ranches often keep the patio off the sliding door, while newer river houses may have bigger decks and pool areas. Tell the contractor which you have when you book your free estimate.
Sweetwater, near I-295 and Wilson Boulevard, was developed from 1949 to 1953 as the Sweetwater Park subdivision, and its streets carry names such as Luke, Matthew and Esther. Each block there was laid out and paved in its own time. If your home is in Sweetwater, call (904) 849-6734 and give the street. Streets with Biblical names make the area easy to place on a map.
Cedar Hills Estates homes run from 910 to 3,248 square feet, and 21 of the current listings report no HOA. That means no association review stands between you and a sealing date. If you do live under an association, check its rules first and then book your free estimate. The decision is yours alone, which keeps scheduling simple.
What does paver sealing cost in Cedar Hills?
A Cedar Hills quote sits between $1.75 and $3.25 per square foot, the published Northeast Florida range, and covers the wash, new sand and a coat. A long Cedar Hills driveway adds square feet but lowers the cost per foot, while lost sand, ditch silt and an old coat that must come off push a quote up. To get numbers for your lot, book your free estimate.
Ditch banks, slopes and a long run to the street change the work. Stripping an old oil-based coat adds cost, and the quote should say so. A front walk and a back patio may price better together. Call (904) 849-6734 and the contractor can answer.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $525 to $975 |
| 600 sq ft | Two car driveway | $1,050 to $1,950 |
| 1,000 sq ft | Large driveway or pool deck | $1,750 to $3,250 |
| 1,500 sq ft | Driveway plus pool deck | $2,625 to $4,875 |
Math based on the $1.75 to $3.25 per square foot that Northeast Florida paver companies published as of November 2026. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.
How does a paver sealing job work in Cedar Hills?
Walk the lot
The contractor measures the drive, the patio and any walk, then checks the garage apron and ditch edges for dips. Past owners may have added pavers in stages, so the old coat is traced first. Mention anything you know about earlier work. A sketch of the lot or a few photos helps the first visit.
Wash the long drive
Tire marks on the drive, silt near ditches and green growth in shade come off first. Pavers near a ditch bank may be washed last so silt does not run back over clean areas. Rust and oil are treated here, before sealer can lock them in. A weak stain may lift on the first pass, while a deep one may only fade.
Top up the sand
Each wash thins the joints, so sand is refilled and swept clean. Sandy Duval ground takes more sand than you would guess, and joints along a planting bed drain faster. The sand color is chosen to match the pavers so the surface reads as one piece.
Dry through
Summer storms can arrive quickly, and pavers in shade or near a ditch dry more slowly than a sunny drive. The contractor watches the forecast and may start late on a damp morning. Evening dew can slow the first coat on a shaded back patio.
Seal and stay off
A sprayer applies the finish, and a roller works it in. Sealer from one Jacksonville company needs 2 to 4 hours before anyone walks on it and 24 hours before cars. Local quotes run two to five years between coats, so ask where your lot lands. A quick bead check a few weeks later shows whether the coat took evenly.
Complete paver services in Cedar Hills
On a ranch lot the work runs in this order: look it over, wash, put the sand back, let it dry, coat it. A long Cedar Hills drive adds square feet to every move but follows the same order. The slow part is usually the dry-through. To ask how your lot would go, call (904) 849-6734.
Every surface on a ranch lot has its own wear pattern. In full sun the drive bakes and wears under tires, beside the sliding door the patio sees chairs and shade, and a pool deck takes splash. List yours when you book your free estimate and each gets a plan.
Reseal timing depends on exposure. A Jacksonville company figures full-sun drives at 18 to 24 months and shaded walks with light traffic at 24 to 36 months, while a cost guide says most pavers need recoating every three to five years. Ask which number fits your lot, or call (904) 849-6734 for an estimate.
Weather sets the calendar. Rain builds from May to September in short, heavy bursts, and shaded pavers by the river dry slowly. One Jacksonville company puts full-sun drives at 18 to 24 months between coats, so check them sooner than shaded walks. For an open date on your street, book your free estimate.
Questions to ask before you hire
- Do you seal in the morning or later in the day, with how hot the pavers get by noon?
- What can you do about the white powder that keeps coming up on my pavers?
- Will you rinse the leftover sand off the pavers and out of the pool before you leave?
- How long do the pavers dry after the wash before the sealer goes on?
- Is there anything I should move, or a gate I should leave open, before you arrive?
- Are my pavers concrete or travertine, and does that change the sealer you pick?
- Can you price the driveway and the back patio as two separate jobs?
What do sealed pavers look like around Cedar Hills?
Why local matters in Cedar Hills
Someone who works Cedar Hills regularly knows that most homes are 1950s ranches with decades of owners behind them. Pavers on a single lot may come from three different years. That history sets how much washing and sand come before sealing. To reach a contractor familiar with these streets, call (904) 849-6734.
Ditches matter in this neighborhood. A large network of drainage ditches and canals crosses Cedar Hills, and in 2017 a blocked drain sent water onto neighboring lots. A nearby contractor asks where water goes on your street. If you are unsure, book your free estimate and describe your lot.
Westside weather is hot and wet in summer, with brief, heavy storms. A crew from the area starts early and builds in extra drying time for shaded patios near the river. To ask when a crew could fit your street into the schedule, book your free estimate. A morning slot works best for most lots.
What should a contractor know about Cedar Hills' shopping center and parks?
Cedar Hills grew around the Cedar Hills Shopping Center, a 282,000 square foot complex finished in 1955, one of Jacksonville's first large shopping districts outside Downtown. Anchor Plaza on 103rd Street opened in 1970. Street names like Mother Goose Road, Peter Pan Place and Flopsy, Mopsy and Cotton Tail lanes give the area a storybook feel. If you live near the old shopping center, call (904) 849-6734 and say so.
Cedar Hills Park has a public pool and a pedestrian bridge that links nearby backyards, and the Mary Lena Gibbs Community Center fills the former National Guard armory from 1957. Cedar Hills Elementary opened in 1956 and Jefferson Davis Middle followed in 1961. Cedar Hills Baptist Church on Jammes Road dates to 1960. If you live close to any of these spots, book your free estimate and give the nearest cross street.
Frequently Asked Questions
Why is paver sealing so expensive in Cedar Hills?
Prep is most of the bill. A long Cedar Hills drive means hours of washing, sand and drying before any sealer goes down. The sealer itself is a small share of the price. Small jobs are priced higher per foot. Ask for each step to be listed so the total makes sense.
What sealer do contractors choose in Cedar Hills, water-based or solvent-based?
Whatever is on the pavers now decides the choice. A water-based coat cannot cover a solvent-based one, and old oil-based coats may need stripping first. Write down the product name for later. A hidden corner is a good place to test a new product.
How long does paver sealing last in Cedar Hills?
Companies commonly quote two to five years. A long sunny drive here may need attention at 18 to 24 months, while a shaded walk can reach 24 to 36. Water that sinks in rather than beading says the coat has failed. Ask when to recheck the coat. A hidden corner is the usual place to check.
How much does it cost to have pavers cleaned and sealed in Cedar Hills?
Expect $1.75 to $3.25 per square foot for the full wash, sand and coat, the published Northeast Florida range. Ditch silt, lost sand and old coats shift a Cedar Hills job within it. Check that square feet appear on the quote.
Do Cedar Hills pavers need re-sanding before sealing?
Yes, because the wash empties the joints. Sand goes back in before sealing so rain cannot reach the base, which one Jacksonville company names as a main cause of sinking. Joints beside a planting bed usually need the most.
What if my Cedar Hills pavers have an old oil-based sealer?
Sometimes. One Jacksonville company strips old oil-based sealer on about 10 to 20 percent of its projects, and that adds cost. The contractor identifies the old product before quoting. Strip work adds cost, so the quote should say so.
Does my Cedar Hills HOA need to approve sealing?
It depends on your street. Many Estates listings report no HOA, so many owners decide alone. If an association does cover you, check its exterior rules before booking. Keep any note from the board with your paperwork.
How soon can I use my Cedar Hills driveway after sealing?
One Jacksonville company's sealer needs 2 to 4 hours before foot traffic and 24 hours before cars. Ask your contractor for the exact time on your job. Keep pets and kids off until it has set. Cars should wait the full time even if the surface feels dry.
Ready for a Free Estimate in Cedar Hills?
Call (904) 849-6734 and tell us about your pavers.
Free, no obligation